Video Conferencing Lighting Kit & Accessories Support

The ring light is optimized to help you look your best in typical work environments. It provides optimum light when the subject is within 5 feet (1524 mm) of the light. Brighter lights are typically used for video production environments where the light needs to be further from the subject.

The cool light setting compensates for room lighting that is too warm or yellow. The warm setting compensates for room lighting that is too cool or blue. The natural setting provides extra natural light when the room lighting is too dim.

The ring light requires a 5V/2.0A USB connection. Your USB probably does not provide sufficient power. To solve this issue, you can try a different USB port on your computer or use a common USB wall adapter and plug the ring light into the wall.

Yes, your ring light came with an adapter that you can screw into the inner bottom center of your ring light and mount your camera to the top of it.

The swivel mount provides additional positioning flexibility. You can mount it to your ring light and then mount your ring light to a stand for maximum positioning flexibility.

The cable management clip allows you to run your accessory cables through a streamlined channel to keep your set up more organized. The clip is especially helpful if you need to reposition your camera on a regular basis since the corresponding cables will remain connected to your setup.

The base measures 7” in diameter.

The desktop stand is equipped with a 3/8” thread commonly used for USB condenser microphones and some lighting systems. The 1/4” adapter allows you to mount webcams and ring lights. The 5/8” adapter allows you to mount professional XLR condenser microphones.

The A1010 extends from 11.8” to 19” to accommodate different webcam, microphone, and lighting configurations.

No, you do not need to leave slack in your cable as long as the cable has slack when it leaves the boom arm.

No, it has a built-in cable channel that allows you to route cables through the length of the product for a clean and tidy setup.

The A1020 can support standard webcams, lighting systems and microphones weighing up to 2.2lbs (0.99kg).

The boom arm is equipped with a 3/8” thread commonly used for USB condenser microphones and some lighting systems. The 1/4” adapter allows you to mount webcams and ring lights. The 5/8” adapter allows you to mount professional XLR condenser microphones.

Yes, the base can swivel a full 360°.

The first joint (bottom) moves from +60° to -20°. The second joint (middle) moves from +45° to -90°. The end joint (top) moves from 0° to -240°.

Yes, the springs are internal for silent operation and to ensure that accessory cables do not interfere with movement.

You may need to adjust the internal springs. Remove the arm from its base. Inside the bottom of the arm, you will see a screw. Tighten that screw a few turns, and it will reduce the slack at the joints.

The cable management clips allow you to run your accessory cables through a streamlined channel to keep your set up more organized. The clips are especially helpful if you need to reposition your stand on a regular basis since the corresponding cables will remain connected to your setup.

The A1000 attaches to desks and platforms ranging from 0.5” to 3.5” to provide stable support for accessories.

The c-clamp is equipped with a 3/8” thread commonly used for USB condenser microphones and some lighting systems. The 1/4” adapter allows you to mount webcams and ring lights. The 5/8” adapter allows you to mount professional XLR condenser microphones.

The swivel mount provides additional positioning flexibility when used with our webcams or ring light.

The C-Clamp extends from 20” (508mm) to 30” (762mm) to accommodate standard webcam, microphone, and lighting configurations.